Modular Fighting Order Carrier Rig (MOFOCr)

The MoFOCR is tailored to work with body armour. The modular design allows for load-out configuration based on mission requirements.

🇨🇦🇺🇸 Made in the USA & Canada.

Listed below are some pre-configured Vest Load-Out possibilities:

RifleMan's Rig Loadout (Shown below)

A) 3 x 3-2 Ammo Mag Pouch (#4005)

B) 1 x IFAK Pouch (#4004)

C) 1 x Utility Pouch (#4031)

C6-C9 Gunner Loadout (Shown below)

D) 2 x 200 Round C9 Pouch (#4045)

B) 1 x IFAK Pouch (#4004)

C) 1 x Utility Pouch (#4031)

E) 1 x 100 Round C9 Pouch(#4032)

Commanders Kit Loadout (Shown below)

A) 3 x 3-2 Ammo Mag Pouch (#4005)

B) 1 x IFAK Pouch (#4004)

C) 1 x Utility Pouch (#4031)

F) 1 x PRR Radio Pouch (#4038)

Features:

1. Brit PLCE COP vest style zippered map pockets accessible from outside the rig. Internal PALS webbing sewn at a 45 degree angle to allow easy access to PRR Radio, GPS, compass. Could also be used to stow chemlights, markers, flex cuffs.
2. Drinking tube and comms wires can be routed internally and through a unique built-in channel in the shoulder straps to avoid snags.
3. Rugged reinforced Drag Handle on rear. 

Ergonomics:

The MoFOCRs suspension allows for a more effective and stable carriage of the fighting load than a conventional Tac-Vest. A combination of a lower back stabilization strap and 2 x 45 degree angled straps connect the rear of the harness panel to the shoulder straps. The overall result is a very stable set up under heavy loads and intense body movement. Additionally, this setup eliminates tangled or twisted lateral side straps associated with regular Tac Vests. The rear of the vest is left intentionally clear to allow for pack placement or ease of sitting in a vehicle/aircraft. Shoulder straps pivot with “D” ring in back to allow for a wide spread comfortable fit over armour.

Innovation:

A traditional Chest Rig maximizes surface area but can be complicated to take off. A traditional split front vest style rig allows ease of donning or removing but sacrifices surface area known as “vest gap”. The MoFOCr vest does not use a conventional zipper or side-release method of closure. Our vest offers an innovative “sub-surface” mounted ITW Nexus 1775 ¾” ‘Snapdragon’ system. This system minimizes vest gap and allows an easy method of quick removal. Simply tug the lanyard upwards or outwards and the buckle will release regardless of load weight. No need to squeeze two recessed buttons together. Works extremely well with gloves or mittens.

Cadpat Desert Available - Minimum order of 15 units.